Manual PIEPS PRO BT/POWDER BT | Firmware v3.0 | 02/2023
27 / 28
6.5 DISPOSAL
Please note that the device is an electronic device. It cannot therefore be
disposed by public waste management companies. Dispose of the device in
accordance with the law in your country.
7. CONFORMITY
EUROPE
Hereby, Pieps GmbH declares that the radio equipment type PIEPS PRO BT/POWDER BT is in compliance with
Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet
address:
www.pieps.com/conformity
UK
PIEPS GmbH declares that the radio equipment type PIEPS PRO BT/PIEPS POWDER BT is in compliance with
Electromagnetic Compatibility Regulations 2016, Radio Equipment Regulations 2017, The Restriction of the Use
of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012, Electrical Equipment
(Safety) Regulations 2016.
The full text of the UK declaration of conformity is available at the following internet address:
www.pieps.com/conformity
USA/CANADA
Manufacturer: Pieps GmbH | Type/Model: PRO BT/POWDER BT
FCC ID: REMDSP04 | IC: 7262A-DSP04
USA: FCC Notice, Cautions and Statement
This device complies with the Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residual installation. This equipment generates, uses and can radiate frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
To assure continued compliance, any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets
the FCC radio frequency (RF) Exposure Guidelines. This equipment has very low levels of RF energy that are
deemed to comply without testing of specific absorption ratio (SAR).
Canada: IC Notice
This device complies with Industry Canada’s licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference; and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
To Next Page
Loading...
