PIEPS PRO BT User Manual

Manual PIEPS PRO BT/POWDER BT | Firmware v3.0 | 02/2023
12 / 28
4.4 GROUP CHECK
The PIEPS PRO BT/POWDER BT provides the option for a group check. This does not
replace the Mode Check, but is a useful feature, to ensure that your groups’ transceivers are sending correctly. In
group check mode the receiving range is limited to 1 m.
Group Check Regular
PIEPS PRO BT/POWDER BT
Check: signal, frequency
Group Check Extended
PIEPS PRO BT
Check: signal, frequency, pulse, period
Start
1. Turn on the device by switching into
send mode
2. Wait till the group check (CH) symbol is
indicated on the display.
3. Press and hold the button MARK during
the group check countdown (CH). The
group check mode is active, as long the
button MARK is pressed.
1. Turn on device by switching into send
mode
2. Wait till the group check (CH) symbol is
indicated on the display.
3. Press and hold the button SCAN during
the group check countdown (CH). The
group check mode is active, as long the
button SCAN is pressed.
Results
Device not transmitting or
distance too big (> 1 m)
Device not transmitting or
distance too big (> 1 m)
Distance reading: device
transmitting and frequency
according to standard
Distance reading: device
transmitting and frequency
according to standard
Device transmitting but
frequency not according to
standard
Device transmitting but
frequency not according to
standard
More than one signals within
1 m range
=> increase distance
Continuous wave indication | old-device-indication.
End
Release the button MARK/SCAN to end the group check mode. During the 3 seconds countdown
the group check mode can be activated again.
The Regular group check is sufficient for checking modern, digital devices with 3 antennas.
The Extended group check is recommended for checking old devices (analog single-antenna devices).

PIEPS PRO BT Specifications

General

Brand	PIEPS
Model	PRO BT
Category	Transceiver
Language	English