Pierce HUSKY 3 - Page 67

© 2022 Pierce Manufacturing Inc. All Rights Reserved. Husky 3 Foam System / Index-1
INDEX
A
Acceptable Foam Concentrate
Viscosity Range
.............................. 2-2
After Every Use Inspection ........................ 4-20
Annual Inspection .................................... 4-21
B
Blowing Out After Testing ............................ 4-2
C
Calibration ................................................ 4-2
Characteristics, Hydraulic Oil ..................... 4-22
Check Current Software Revision .................. 4-5
Checking Hydraulic System Pressure ............ 4-5
Class A Foam - Drafting .............................. 3-2
Class A Foam - using on-board Foam Tank .... 3-1
Class B Foam - Drafting .............................. 3-3
Control Head .......................................... 2-13
Control System ....................................... 2-12
Customer Assistance Information ..................... v
D
Description of “DANGER,” “WARNING,” and
“CAUTION”
.................................... 1-1
Description of Major Components ................. 2-2
Discharges ............................................... 2-1
Draining Foam Pump After Testing (with water in draft
mode and foam in foam cell)
............. 4-1
Draining Foam Pump After Testing (with water in foam
cell)
.............................................. 4-1
E
Electrical System ..................................... 4-26
Explanation of Columns ............................ 4-20
F
Fill through Foam Tank Fill Dome ................ 3-10
Filling Foam Tank ..................................... 3-7
Flushing After Drafting Class A Foam ............ 3-5
Flushing After Drafting Class B Foam ............ 3-5
Flushing System ....................................... 3-4
Foam Concentrate Compatibility .................. 2-2
Foam Concentrate Pump ............................ 2-8
Foam Concentrate Tank ............................. 2-7
Foam Injection Check Valve ....................... 2-11
Foam Proportioner .................................... 2-1
Foam Selector Valve (Injection/Fill) (100ft Ascendant
Aerial Tower Only)
.......................... 2-9
Foam Selector Valve (Injection/Fill) (ALL except 100ft
Ascendant Aerial Tower)
.................. 2-9
Foam Supply System ................................. 2-7
Foam Supply Valve ................................... 2-7
Foam System Operation ............................. 3-1
Foam System Schematic ........................... 4-25
G
General Flushing Information ....................... 3-4
General Maintenance Procedures ............... 4-19
H
Husky 3 Specifications ............................... 2-1
Hydraulic Drive System .............................. 2-2
Hydraulic Gear Pump ................................. 2-3
Hydraulic Gear Pump Electrical Components .. 2-4
Hydraulic Manifold Block ............................ 2-6
Hydraulic Oil Cooler ................................... 2-6
Hydraulic Oil Filter ..................................... 2-5
Hydraulic Oil Reservoir ............................... 2-5
Hydraulic Schematic ................................. 4-24
Hydraulic Tank ........................................ 4-19