Pilz PNOZ X9P - Page 24

PNOZ X9P
Operating Manual PNOZ X9P
1003362-EN-12
| 24
Electrical data 777607 777609 787609
Supply voltage
Voltage 12 V 24 V 24 V
Kind DC DC DC
Voltage tolerance -20 %/+20 % -15 %/+10 % -15 %/+10 %
Output of external
power supply (DC) 7 W 5,5 W 5,5 W
Residual ripple DC 160 % 160 % 160 %
Duty cycle 100 % 100 % 100 %
Max. inrush current im-
pulse
Current pulse, A1 5,5 A 10 A 10 A
Pulse duration, A1 1 ms 1 ms 1 ms
Inputs 777607 777609 787609
Number 2 2 2
Voltage at
Input circuit DC 12 V 24 V 24 V
Start circuit DC 12 V 24 V 24 V
Feedback loop DC 12 V 24 V 24 V
Current at
Input circuit DC 130 mA 50 mA 50 mA
Start circuit DC 200 mA 100 mA 100 mA
Feedback loop DC 200 mA 100 mA 100 mA
Min. input resistance at
power-on 9 Ohm 89 Ohm 89 Ohm
Max. overall cable resist-
ance Rlmax
Single-channel at UB
DC 8 Ohm 45 Ohm 45 Ohm
Dual-channel without
detection of shorts
across contacts at UB
DC 15 Ohm 90 Ohm 90 Ohm
Dual-channel with de-
tection of shorts across
contacts at UB DC 8 Ohm 15 Ohm 15 Ohm
Semiconductor outputs 777607 777609 787609
Number 2 2 2
Voltage 12 V 24 V 24 V
Current 20 mA 20 mA 20 mA
External supply voltage 12 V 24 V 24 V
Voltage tolerance -20 %/+20 % -20 %/+20 % -20 %/+20 %
Residual current at "0"
signal 0,1 mA 0,1 mA 0,1 mA
Max. internal voltage drop 4 V 4 V 4 V
Conditional rated short cir-
cuit current 100 A 100 A 100 A
Lowest operating current 0 mA 0 mA 0 mA