Contents
Operating Manual PSENvip RL D P Set
1001641-EN-09
| 3
1 Introduction ............................................................................................................................ 6
1.1 Validity of the documentation.................................................................................................... 6
1.2 Overview of documentation ...................................................................................................... 6
1.3 Definition of symbols................................................................................................................. 7
2 Overview ................................................................................................................................. 8
2.1 Scope of supply ........................................................................................................................ 9
3 Safety ...................................................................................................................................... 10
3.1 Intended use ............................................................................................................................. 10
3.1.1 Approvals.................................................................................................................................. 11
3.1.2 Safety during operation............................................................................................................. 11
3.1.2.1 Hazards arising from the installation of the PSENvip ............................................................... 11
3.1.2.2 Hazards arising from a reduced protected field ........................................................................ 11
3.1.2.3 Hazards arising from incorrect handling of the workpiece ........................................................ 11
3.1.2.4 Correct handling of the workpiece ............................................................................................ 12
3.1.3 Categories / SIL ........................................................................................................................ 13
3.1.4 Tool shapes .............................................................................................................................. 14
3.2 Standards ................................................................................................................................. 16
3.3 Safety guidelines ...................................................................................................................... 16
3.3.1 Use of qualified personnel ........................................................................................................ 17
3.3.2 EMCD ....................................................................................................................................... 17
3.3.3 Warranty and liability ................................................................................................................ 17
3.3.4 Safety during commissioning, installation and operation.......................................................... 17
3.3.5 Disposal .................................................................................................................................... 17
4 Function description ............................................................................................................. 18
4.1 Overview................................................................................................................................... 18
4.2 Protected field........................................................................................................................... 21
4.2.1 Dynamic muting ........................................................................................................................ 22
4.2.2 Standard interrupted press stroke ............................................................................................ 24
4.3 Overrun..................................................................................................................................... 25
4.4 Description of the units ............................................................................................................. 26
4.4.1 Overview................................................................................................................................... 26
4.4.2 Transmitter................................................................................................................................ 26
4.4.2.1 Inputs ........................................................................................................................................ 26
4.4.3 Receiver.................................................................................................................................... 27
4.4.3.1 Inputs ........................................................................................................................................ 27
4.4.3.2 Outputs ..................................................................................................................................... 28
4.4.3.3 LED........................................................................................................................................... 30
4.4.3.4 Key display and function........................................................................................................... 30
4.4.4 Communication with the safety system .................................................................................... 33
4.5 Protected field modes ............................................................................................................... 36
4.5.1 Standard protected field mode.................................................................................................. 37
4.5.2 Box bending protected field mode ............................................................................................ 38
4.5.3 Back gauge protected field mode ............................................................................................. 39
4.5.4 Box bending with back gauge protected field mode ................................................................. 40
4.6 Operating modes during commissioning .................................................................................. 41
To Next Page
Loading...