Pilz PSS Series Installation Manual

7-1Installation Manual: PSS 3056 Series
Changes to the Installation Manual
Changes from version IV to version V
The Installation Manual was completely revised and is now also valid for
the PSS SB 3056.
The most significant changes are as follows:
• Chapter entitled "Safety Regulations" was restructured and the contents
corrected.
• Page 3-3, description of how to earth the 0 V supply was added.
• Page 3-3, section entitled "Cabling" was amended.
• Page 3-5, section entitled "Suppression of inductive loads" was
amended.
• Page 5-1 to 5-4, connector descriptions for the PSS terminal blocks was
added.
• Chapter 5 was completely revised.
• Chapter 6 was added to include a description of the interface
configurations.
Changes from version V to version VI
Page 3-5, section entitled "Insulation voltage test" was added.
Changes from version V to version VI
• Page 2-4, Condensation is not permitted.
• Page 2-5, the use of wiring which can withstand insulation temperatures
of 75° C is no longer specified.
Appendix
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com

Pilz PSS Series Specifications

General

Category	Safety Equipment
Manufacturer	Pilz
Safety Standards	EN ISO 13849-1, IEC 61508, IEC 62061
Series	PSS
Safety Integrity Level	SIL 3
Communication Interfaces	Ethernet, PROFIBUS, PROFINET
Operating Voltage	24 V DC
Operating Temperature	0°C to +55°C (typical), others depending on model
Storage Temperature	-20°C to +70°C (typical), others depending on model
Protection Class	IP20
Application	Industrial safety applications