5-10
Functions
PSS WIN-PRO Service Version: Getting Started
9. Activate program display for additional blocks
It is not possible to run the program display for several blocks
simultaneously, but you can start dynamic program display for several
blocks and then activate the window of the block for which the program
display is to be run. A block that is called up at several points within the
program can only be opened once, but you can define which of the
block calls is displayed via the program structure.
Carry out steps 4 and 5 for any additional blocks and then activate the
window containing the block for which program display is to be run.
10. Stop dynamic program display
The program display must be stopped separately for each block. Only
if you have opened the PSS program can you stop the program display
for all blocks in one go by closing the program.
Select
PSS -> Dynamic Program Display -> Stop Dynamic Program
Display
or close the block.
To Next Page
Loading...
