17
FM radio mode
FM radio mode receives analogue radio from the FM band and displays RDS
(Radio Data System) information about the station and show (where broadcast).
To enter FM mode, press SOURCE > turn SELECT control until the display
shows FM radio. Press SELECT to select the mode.
Selecting stations
To find a station, press and hold 9 or :. The frequency display starts to run as
Supersound 101 scans the FM band.
Now playing information
While an FM station is playing, the screen shows one of the two following sets
data:
• If RDS information is available, by default the service name (i.e. station name)
is displayed.
You can cycle through further RDS information by pressing INFO. Each time
you press INFO, another set of information is displayed, cycling through RDS
radio text, RDS program type, frequency and today’s date.
• If no RDS information is available, the currently tuned frequency is shown.
Scan settings
By default, FM scans stop at any available station. This may result in a poor
signal-to-noise ratio (hiss) from weak stations. To change the scan settings to
stop only at stations with good signal strength, select MENU > Scan setting >
Strong stations only? > Yes.
Audio settings
By default, all stereo stations are reproduced in stereo. For weak stations, this
may result in a poor signal-to-noise ratio (hiss). To play weak stations in mono,
select MENU > Audio setting > FM weak reception: Listen in mono only >
Yes.
To Next Page
Loading...
