7
Getting started
Supersound 101 is easy to use. To play DAB or FM radio, all you need is a
power source (batteries or 100-240V mains supply). For Internet radio and
Podcasts, you also need a broadband Internet connection.
Setup Wizard
When Supersound 101 is started for the first time, it runs through a setup wizard
to configure settings for date/time and network.
To change these settings later, select MENU > System settings > and select
the required settings option(s).
To run the setup wizard again, select MENU > System settings > Setup
wizard.
The Network settings can be reset later manually running the Network wizard,
select MENU > System settings > Network > Network wizard.
Note: If power is removed while the wizard is in progress, the wizard will run
again next time Supersound 101 is started.
12/24 hour display
To change between 12 and 24 hour display, select Time/Date > Set format and
then select your preference.
Set Time/Date
The date and time are displayed as dd-mm-yyyy and hh:mm with the first value,
dd, active (flashing).
Adjust each value by turning Select control. As each value is set by pressing the
Select control, the next value becomes active ready for adjustment.
Auto-update
Auto-update works with data sent over DAB, FM or network. The clock is only
updated when in a corresponding mode, so it is best to select a mode you use
regularly.
DAB and FM use time signals broadcast with radio transmissions.
To Next Page
Loading...
