To Next Page

To Previous Page

PDP-433PU

1234

6. ADJUSTMENT

6.1 SERVICE FACTORY MODE

Remote Control Unit Operation in The Service Factory Mode

Operate the service factory mode with the remote control unit (AXD1463, AXD1460 or AXD1471) supplied with the Media

Receiver.

Please perform the adjustment using the following keys.

Service factory mode uses an OSD function of the Media Receiver (PDP-R03E, PDP-R03U or PDP-R03G).

Perform the adjustment and setting when the Media Receiver is connected with this unit.

Service Factory mode cannot be used if the Media Receiver is not connected with the Plasma Display.

Keys on the

Remote

Control Unit

Functions

P + key

Each press of the key moves the adjustment-item-selection cursor

up by one line.

P – key

Each press of the key moves the adjustment-item-selection cursor

down by one line.

VOL + key

Each press of the key increases the adjustment value by one.

VOL – key

Each press of the key decreases the adjustment value by one.

5 key

Each press of the key moves one page backward (previous page).

∞ key

Each press of the key moves one page forward (next page).

2 key

Each press of the key decreases the adjustment value by 10.

3 key

Each press of the key increases the adjustment value by 10.

"P +" key

"P –" key

* "0" key

* : Refer to

"6.1.1 How to

Enter Service

Factory Mode".

* "MENU"

key

* "ENTER"

key

"5" key

"∞" key

"2" key

"3" key

"VOL +" key

"VOL –"

key