Press the "Factory" key (Note 1)
Switch pages
with "5" and "∞" keys.
Press the "Factory" key (Note 1)
Press the " (POWER)" key (POWER OFF)
System standby
Confirm that both the Plasma Display and the Media Receiver are turned on and
a system cable is connected properly.
Image receiving
Page 1/18
General information about the Plasma Display and Media Receiver
Service Factory Mode
Page 2/18 to 9/18
Adjustment and setting items of the Media Receiver
Page 11/18, 13/18
Adjustment and setting items of the Plasma Display
Note 1: If the remote control unit for adjustment with the factory (AA5F) code is used.
Perform the following operations within 3
seconds using the remote control unit .
• Press the "MENU" key.
• Press the "ENTER" key.
• Press the "0" key.
Note: The actual page structure may be different.
To Next Page
Loading...
Need help?
General