USER MANUAL Page 28 of 69
B. Place the main body into its space in the carrying case.
C. Pack the footswitch, the power cable, and all other accessories in their pouches
into appropriate spaces inside the carrying case.
H1 has two power supply modes: external adapter power supply and internal lithium
battery. H1 needs away from the wall at least 200 mm to ensure smooth ventilation
and facilitate power switch operation. Press the power switch to the ON position to
start the device.
External power supply: Directly insert the adapter plug which specified by our
company into the DC jack on the rear panel of the device, the other plug of the
adapter into the grounded mains network to prevent electric shock;
Adapter parameters:
Input: 110~220VAC
，
50/60Hz
Output: 18VDC, 5.55A
Internal lithium battery power supply: When using lithium battery, directly dial the
power switch to the ON position. When the battery power is lower than 10%, the laser
stops working and prompts the user by sound, graphic and indicator light to charge
the battery.
Battery capacity: 3350mAH.
Note
DO NOT allow fiber twisted or bent with radius less than 50mm.
Note
When connecting to external power supply, it is fist use external power to
supply.
Note
Please use the battery specified by our company. The battery is certified by
safety inspection, aviation, etc. And meets EU standards.
To Next Page
Loading...