USER MANUAL Page 38 of 69
Make sure the following tasks are completed before you start the laser device:
Operators, patients and others present have worn laser safety goggles;
The power line of the equipment is connected to the outlet of the external power
supply, and the outlet is well grounded;
The laser handpiece is firmly connected to the device;
The Interlock is well connected.
1）Turn on the power supply of the system, the power indicator lights up, the
system fan runs, and the LCD screen lights up;
3）Enter in the home page.
Note
There are three output modes: continuous, pulse and single pulse in the H1
diode dental laser. The operator should choose a suitable protocol
according to the patient's condition and treatment.
If the control device, regulator or is not used or operated according to the
prescribed method, dangerous radiation will be produced, which will cause
injury and damage to people and equipment. Among them, the control
devices and regulators include: LCD display, emergency stop switch, key
switch, Interlock, foot switch, etc.
To Next Page
Loading...