Pit Boss PB4GRT - Installing the Casters; Assembling the Door Catch Plate; Installing the Cart Side Panels; Securing the Cart Back Panel

2.   
Parts Required:
2 x Casters (Z)
2 x Locking Casters (V)
16 x Screw (BB)
16 x Lock Washers (DD)
Installation:
• With the cart base (W) laying upside down, attach the 2 casters (Z) as
shown to the left side of the cart base (W) using 8 screws (BB) and 8
lock washers (DD).
• Next, install the 2 locking casters (V) to the right side of the cart base
(W) using 8 screws (BB) and 8 lock washers (DD).
3.     
Parts Required:
1 x Door Catch Plate (Y)
2 x Screw (AA)
Installation:
• Flip over the cart base (W) and lock the locking casters (V).
• Attach door catch plate (Y) to cart base using 2 screws (AA).
4.     
Parts Required:
1 x Left Cart Side Panel (P)
1 x Right Cart Side Panel (B1)
6 x Screw (CC)
Installation:
• Attach left cart side panel (P) to cart base (W) using 3 screws (CC).
Attach right cart side panel (B1) to cart base using 3 screws (CC).
5.     
Parts Required:
1 x Cart Back Panel (I)
7 x Screw (CC)
Installation:
• Attach cart back panel (I) to cart base (W) using 1 screw (CC). Fasten
cart back panel (I) to the left side cart panel (P) and right side cart
panel (B1) using 6 screws (CC). Fasten the top screw on either side,
then move downward.
8
2
3
4
5