Pitco SELV Series - Page 2

L22-393 R0 Page 2
! DANGER !
Improper installation, operation, adjustment, maintenance, all alterations or service, and unauthorized
alterations or modifications can cause property damage, injury or death. Read the installation, operating
and service manuals thoroughly before installing or servicing this equipment.
! DANGER !
Prior to moving, testing, maintaining or repairing your appliance, ensure it is emptied of all oil, cool,
disconnected from electric and all electrical power. Failure to do so may result in property damage,
damage to your fryer, injury or death.
! DANGER !
DO NOT sit or stand on this appliance. The appliance’s top deck, door, front panel, tank, splash back,
tank cover, workshelf, drain board are not steps. Serious injury will result from slipping, falling or contact
with hot liquids causing property damage, injurious severe burns and/or death.
! DANGER !
NEVER use the appliance as a step for cleaning or accessing the ventilation hood. Serious injury will
result from slipping, falling or contact with hot liquids causing property damage, injurious severe burns
and/or death.
! DANGER !
Do not store or use electricoline, store or spray aerosols or other flammable liquids or vapors in the
vicinity of this or any other appliance. Appliances incorporate open flames and/or high heat that will
ignite flammable vapors causing property damage, injury and death.
! DANGER !
No structural material on the fryer should be altered or removed to accommodate placement of the fryer
under a hood.
! DANGER !
All fryers shipped without factory supplied cords and plug assemblies must be hardwired using flexible
conduit to the terminal block located on the rear of the fryer. These fryers should be wired to NEC
specifications. Hardwired units must include installation of restraint devices.
! DANGER !
Adequate means must be provided to limit the movement of this appliance without depending on or
transmittin
g
stress to the electrical conduit.
! DANGER !
This appliance has a power cord (three-phase) for each frypot. Prior to movement, testing, maintenance
and/or any repair on your appliance; disconnect ALL electrical power cords from the electrical power
supply.
! DANGER !
This appliance must be connected to a power supply having the same voltage and phase as specified on
the rating plate located on the inside of the appliance door.