L22-393 R0 Page 5
NOTE
When installed, this appliance must be electrically grounded in accordance with local codes, or in the
absence of local codes, with the National Electrical Code, ANSI/NFPA 70, the Canadian Electrical Code,
CSA C22.2, or the appropriate national code of the country in which installed.
NOTE
If this equipment is wired directly into the electrical power supply, a means for disconnection from the
supply having a contact separation of at least 3-mm in all poles must be incorporated in the fixed wiring.
NOTE
This equipment must be positioned so that the plug is accessible unless other means for disconnection
from the power supply (e.g., a circuit breaker) is provided.
NOTE
If this appliance is permanently connected to fixed wiring, it must be connected by means of copper wires
having a temperature rating of not less than 167°F (75°C).
NOTE
Some US states require any electrical appliance to be installed by a state licensed electrician. Check with
your local municipality prior to installation.
NOTE
This equipment must be installed in accordance with appropriate local and national codes in the state,
country and/or region in the appliance is to be operated. Contact your local electric authority for
guidance.
NOTE
This equipment is to be installed in compliance with the basic plumbing code of the Building Officials and
Code Administration International (BOCA) and the Food Service Sanitation Manual of the U.S Food and
Drug Administration.
NOTE
Photos and drawings used in this manual are intended to illustrate operational, cleaning and technical
procedures and may not conform to onsite management operational procedures.
NOTE
This appliance is intended to be used for commercial applications: For example in kitchens of
restaurants, canteens, hospitals and in commercial enterprises such as bakeries, butcheries, etc. but
NOT for continuous mass production of food.
NOTE
This appliance is intended for professional use only and is to be operated by qualified, trained personnel
only. A Pitco Authorized Service Agent (ASA) or other qualified professional must perform installation,
maintenance and repairs. Installation or repairs by unqualified personnel will void the manufacturer’s
warranty. See chapter one for descriptions of qualified personnel.
NOTE
If, during the warranty period, the end user uses a part for this Pitco appliance other than an UNMODIFIED
new part purchased directly from Pitco or any of Pitco’s authorized service agents, and/or the part being
used is modified from its original configuration, THE WARRANTY WILL BE VOID. Further, Pitco Frialator
and its affiliates will not be liable for any claims, damages or expenses incurred by the customer which
arise directly or indirectly, in whole or in part, due to the installation of any modified part and/or part
received from an unauthorized servicer/supplier.
To Next Page
Loading...
