AW32348 Rev D 09/2019
1 2 3
5. Pack the device for shipment back
to Pitney Bowes.
Everything you need to return your system is
included in the white box that your replacement
device arrived in.
If additional packaging is needed or if you have questions,
contact client support at www.pitneybowes.com/us/returns
5a. Place the device inside the plastic bag provided.
5b. Place the device in the white box as shown in the
illustration.
5c. Seal the top of the carton with tape provided.
5d. Apply a prepaid UPS shipping label to the box
over old shipping labels and return via your local
UPS agent or drop off location.
The below list of items should not be returned.
Use these items with a replacement meter or
properly discard these electronic items according
to your local/state/federal codes/regulations.
5e. Keep the customer portion of the prepaid
shipping label so you can track your shipment.
Bottom
Top
Device in
plastic bag
Tape
Label
USB cable LAN cable
Scale Stacker tray
Power cord
Ink cartridge
4i. If you are using the stacker tray, slide that away from
the device.
4j. Dispose of your ink tray (see right).
Pull the ink drawer out from the side of the device.
Remove the ink tray and dispose in the bag provided.
Place the empty drawer back into the device.
4h. Remove the moistener reservoir by removing
three thumbscrews from the bottom of the reservoir.
(hold and remove the reservoir straight in order not to
spill sealing solution.)
Drain the reservoir completely.
Attach the empty reservoir back with the thumbscrews.
Drain resovoir
Thumbscrew
1 2
Moistener
resovoir
To Previous Page
Loading...
Need help?
General
