Telephone Line Powered Auto Dialing emFONE
Copyright © 2014 Pixel Technologies Pty. Ltd
2.2. Site Requirements
Whilst the telephone in itself is quite simple in its approach to wiring and configuration, it is important
to be considerate of the requirements before attempting to install the system on site.
The EM-2 telephone requires the following:
1 x Twisted Pair Telephone Cable.
All cabling for this system should never be run along with high voltage cabling. All efforts must be
made to ensure the cabling is protected from induced noise from external systems.
A shielded cable does not guarantee immunity from noise.
Pixel Technologies assumes no responsibility for incorrect or incomplete cabling installed onsite. A
qualified electrician / telecommunications engineer must always approve and install all components of
a network that are connected to Pixel Technologies equipment. Consult individual product manuals for
electrical specifications
.
Product manual electrical specifications are for a single product only
To Next Page
Loading...
