Pixsys ATR 421 - Page 40

40 ATR 421 - User manual
34 cY.A u . Cycles Available: Selects number of available cycles.
1…15 cycles. > Default: 15.
35 b.pr.c. Block Programming Cycles: Selects number of cycles that the
user cannot modify, to avoid wrong progamming.
Ex.: selecting 3 the programming of  rst 3 cycles is locked.
0…15 locked cycles. > Default: 0.
36 w.t.s.e. Waiting Time Step End: Selects time for step end waiting in
hh.mm.
00.00 Step end waiting excluded
00.01…24.00 hh.mm. > Default: 01.00.
37 m.G.s.e. Max. Gap Step End: Selects max. gap for step end waiting
activation. When the di erence between setpoint and process is
lower than this parameter, controller switch to the next step (also
without waiting time programmed into parameter 36 w.t.s.e.
0…200 [digit
7
] (degrees.tenths for temperature sensors).
> Default: 5.
38 r.i . cY. Recovery Interrupted Cycle: Enables interrupted cycle
recovery function.
0 Cycle recovery disabled
1 Cycle recovery enabled with automatic gradient > Default.
2…9999 [digit
7
]. Select recovery gradient (rising).
39 bu.s.t. Burners Start Time: Time for burners start. De nes the time
elapsed between the burner command activation and the
e ective  ame switch on.
00.00…15.00 mm.ss. > Default: 01.00.
40 t.s.o.b. Threshold Switch O Burners: De nes deviation threshold
above the setpoint over which the burners are switched o .
0…200 [digit
7
](degrees.tenths for temperature sensors).
> Default: 30.
7
The display of the decimal point depends on the setting of parameters Sen. and d.p.