52 ATR 421 - User manual
14 Summary of con guration parameters
Date: Model: ATR421-
Installer: Installation:
Notes:
1
c.out
Select type of command output
2
sen.
Analogue input AI1 con guration AI1
3
d.p.
Select type of visualized decimal
4
Lo .L.i .
AI1 range lower limit, only for linear
5
up.L.i.
AI1 range upper limit, only for linear
6
o.cAL.
AI1 o set calibration
7
G. caL.
AI1 gain calibration
8
Lo .L.S.
Setpoint lower limit
9
up.L.s.
Setpoint upper limit
10
deGr.
Degrees type selection
11
tune
Autotuning type selection
12
s.d.tu.
Deviation from command setpoint for manual
tune
13
m.G.tu.
Max. gap for automatic tune
14
mn.p.b.
Min. proportional band for automatic tune
15
ma.p.b.
Max. proportional band for automatic tune
16
mn.i.t.
Min. integral time for automatic tune
17
----
Reserved
18
act. t.
Regulation type for command output
19
c. HY.
Hysteresis in ON / OFF or dead band in P.I.D.
20
p. b .
Proportional band
21
t.i.
Integral time
22
t.d .
Derivative time
23
t.c.
Cycle time
24
L.L. o . p.
Min. value for command output percentage
25
u.Lo.p.
Max. value for command output percentage
26
c. s. e.
Status of command output contact in case of
error
27
dGt.i.
Digital input functioning
28
d.i.c.t.
Digital input contact
29
ui . d .2
Red display in run visualization
30
de.st.
Initial waiting
To Next Page
Loading...
