User manual - PL500-PL600-PL700 - 5
Introduction
The PLC Pixsys PL500-PL600-PL700 / PLE500 range features a modular and
flexible structure.
The PL500 CPU is a control unit and connectivity node, complete with serial
RS485 and RS232 (Modbus RTU), Ethernet (Modbus TCP/IP) and CanOpen and is
based on an ARM CORTEX A8 -1 GHz microprocessor.
The various combinations of analogue-digital I/O instead reside on the PLE500
modules, which communicate via real-time internal Bus on DIN-rail.
The LogicLab development environment is available in order to program the
logic and can be downloaded from the dedicated area at www.pixsys.net.
1 Safety guidelines
Read carefully the safety guidelines and programming instructions contained in
this manual before connecting/using the device.
Disconnect power supply before proceeding to hardware settings or electrical
wirings to avoid risk of electric shock, fire, malfunction.
Do not install/operate the device in environments with flammable/explosive
gases.
This device has been designed and conceived for industrial environments and
applications that rely on proper safety conditions in accordance with national
and international regulations on labour and personal safety. Any application
that might lead to serious physical dama ge/ life risk or involve medical life
support devices should be avoided.
Device is not conceived for applications related to nuclear power plants,
weapon systems, flight control, mass transportation systems.
Only qualified personnel should be allowed to use device and/or service it and
only in accordance to technical data listed in this manual.
Do not dismantle/modify/repair any internal component.
Device must be installed and can operate only within the allowed environmental
conditions. Overheating may lead to risk of fire and can shorten the lifecycle of
electronic components.
Table of contents
To Next Page
Loading...
Need help?
General
