15
To adjust the mode parameters, press «F1/Settings». Four parameters will appear in the drop-
down menu to select:
• Level scale. Possible values are 5, 10 dB;
• Span. Span range. Possible values are 18, 36, 72 MHz;
• Averaging. Possible values are Off, Low, Medium, High;
• Hold. Additional trace display. Possible values are Off, MIN, MAX.
The level scale can be adjusted with « » and « », going to the setup menu is not needed. To
move a marker or scan window quickly, press « » and one of the arrows «◄» or «►»
simultaneously.
4.4 Data Logger Function
4.4.1 General Information
Data Logger is intended for automation of the procedure of recording the measurement results.
The memory capacity allows to save up to 64 channel plans, up to 16 limit plans, up to 250 channel
data logger pages with maximum number of channels. The Analyzer allows viewing the saved data
off-line or by means of a computer (Section 4.8.2).
4.4.2 Channel Plan List
In the main selection menu, the icon corresponds to the mode. This mode allows
performing all the operations with channel plans: viewing, editing, deleting, and creation of new
pages. See the view of the screen in Figure 4.7. The table contains 2 columns. The first column is a
channel plan name. The second column shows the status of the channel plan. To select a channel
plan, use the « » and « » buttons. Select the required channel plan and press the "F3/Select"
button.
4.4.2.1 Editing Channel Plan
To view and edit the channel plan, select the required one and press “F1/Plan”. In the pop-up
menu, select Edit. The screen view of the channel plan table is shown in the Figure 4.8:
To Next Page
Loading...
Need help?
General