Planet IGS-501T - Wall Mount Plate Mounting

17
Step 5: Lightly press the button of DIN-Rail for remove it from the
track.
2.2.2 Wall Mount Plate Mounting
To install the Industrial Gigabit Ethernet Switch on the wall, please
follows the instructions described below.
Step 1: R
emove the DIN-Rail from the Industrial Gigabit Ethernet
Switch; loose the screws to remove the DIN-Rail.
Step 2: P
lace the wall mount plate on the rear panel of the Industrial
Gigabit Ethernet Switch.
Step 3: Use the screws to screw the wall mount plate on the
Industrial Gigabit Ethernet Switch.
Step 4: U
se the hook holes at the corners of the wall mount plate to
hang the Industrial Gigabit Ethernet Switch on the wall.
Step 5: T
o remove the wall mount plate, reverse steps above.