19
Step 3: To hang the Industrial Gigabit Ethernet Switch on the DIN-
Rail track or wall, please refer to the Mounting Installation
section.
Step 4: P
ower on the Industrial Gigabit Ethernet Switch. (Please refer
to the Wiring the Power Inputs section for power input) The
power LED on the Industrial Gigabit Ethernet Switch will light
up. Please refer to the LED Indicators section for meaning of
LED lights.
Step 5: P
repare the twisted-pair, straight through Category 5 cable
for Ethernet connection.
Step 6: I
nsert one side of Category 5 cables into the Industrial Gigabit
Ethernet Switch Ethernet port (RJ-45 port) and another side
of category 5 cables to the network devices’ Ethernet port
(RJ-45 port), ex: switch, Pc or Server. The UTP port (RJ-45)
LED on the Industrial Gigabit Ethernet Switch will light up
when the cable connected with the network device. Please
refer to the LED Indicators section for LED light meaning.
Be sure the connected network devices support MDI/
MDI-X. If it does not support then use the crossover
category 5 Cable.
Step 7: W
hen all connections are all set and LED lights all show in
normal, the installation is complete.
To Next Page
Loading...
Need help?
General
