User Manual of WDAP-C1800AX &WDAP-1800AX
- 6 -
3.3 Manual Network Setup -- TCP/IP Configuration
The default IP address of the WDAP-C1800AX is 192.168.1.253. And the default subnet mask is
255.255.255.0. These values can be changed as you want. In this guide, we use all the default values
for description.
Connect the WDAP-C1800AX with your PC by plugging one end of an Ethernet cable in the LAN port of
the AP and the other end in the LAN port of PC. The WDAP-C1800AX is powered by a PoE switch.
In the following sections, we’ll introduce how to install and configure the TCP/IP correctly in Windows
10. And the procedures in other operating systems are similar. First, make sure your Ethernet Adapter
is working, and refer to the Ethernet adapter manual if needed.
3.3.1 ConfiguringtheIPAddress Manually
Summary:
Set up the TCP/IP Protocol for your PC.
Configure the network parameters. The IP address is 192.168.1.xxx (If the default IP
address of the WDAP-C1800AX is 192.168.1.253, and the DSL router is 192.168.1.254,
the "xxx" can be configured to any number from 1 to 252.) and subnet mask is
255.255.255.0.
1 Select Use the following IP address, and then configure the IP address of the PC.
2 For example, the default IP address of the WDAP-C1800AX is 192.168.1.253 and the
DSL router is 192.168.1.254, or you may choose from 192.168.1.1 to 192.168.1.252.
To Next Page
Loading...
Need help?
General
