User Manual of WDAP-C1800AX &WDAP-1800AX
- 17 -
Figure 4-7: Setup Wizard – LAN Configuration
Object Description
IP Address
Enter the IP address of your router. The default is 192.168.1.1.
Subnet Mask
An address code that determines the size of the network. Normally
use 255.255.255.0 as the subnet mask.
DHCP Server
By default, the DHCP Server is enabled.
If user needs to disable the function, please uncheck the box.
Start IP Address
By default, the start IP address is 192.168.1.100.
Please do not set it to the same IP address of the router.
Maximum DHCP Users
By default, the maximum DHCP users are 101, which means the router
will provide DHCP client with IP address from 192.168.1.100 to
192.168.1.200 when the start IP address is 192.168.1.100.
Next
Press this button to the next step.
Cancel
Press this button to undo any changes made locally and revert to
previously saved values.
Step 3: WAN Interface
The router supports two access modes on the WAN side shown in Figure 4-8
To Next Page
Loading...
Need help?
General
