Planet WGSW-24040HP4 - End

Command Guide
-303-
Default:
None
Usage Guide:
To enter the SNMP host mode
Example:
To enter the SNMP host mode (planet)
Switch# configure terminal
Switch (config)# snmp-server host planet
Switch (config-snmps-host)#
4.2.212.1 do
Command:
do < exec commands >
do To run exec commands.
Default:
N/A
Usage Guide:
To run exec commands.
Example:
To run “show aaa”.
Switch# configure terminal
Switch (config)# snmp-server host planet
Switch (config-snmps-host)#do show aaa
console : local
telnet : local
ssh : local
http : local
4.2.212.2 end
Command:
end
end Go back to EXEC mode