Planet WGSW-24040HP4 - Dot1 X Guest-Vlan Supplicant; Dot1 X Max-Reauth-Req

Command Guide
-71-
<1-4095> Guest VLAN ID used when entering the Guest VLAN.
Default:
1
Usage Guide:
To set the value of guest-vlan for Network Access Server
Example:
To set the value of guest-vlan(2) for Network Access Server
Switch# configure terminal
Switch (config)# dot1x guest-vlan 2
4.2.31 dot1x guest-vlan supplicant
Command:
dot1x guest-vlan supplicant
supplicant The switch remembers if an EAPOL frame has been received on the port for the life-time of the port. Once the
switch considers whether to enter the Guest VLAN, it will first check if this option is enabled or disabled.
Default:
Disable
Usage Guide:
To allow all frames automatically entering guest-vlan for Network Access Server
Example:
To allow all frames automatically entering guest-vlan for Network Access Server
Switch# configure terminal
Switch (config)# dot1x guest-vlan supplicant
4.2.32 dot1x max-reauth-req
Command:
dot1x max-reauth-req <1-255>