Planet WGSW-24040HP4 - Evc Update

Command Guide
-90-
cbs Setup CBS
<Cbs : 0-100000> Committed Burst Size [bytes]
cir Setup CIR
<Cir : 0-10000000> Committed Information Rate [kbps]
disable Disable policer
ebs Setup EBS for MEF policer
<Ebs : 0-100000> Excess Burst Size [bytes]
eir Setup EIR for MEF policer
<Eir : 0-10000000> Excess Information Rate [kbps]
enable Enable policer
mode Setup policer mode
aware Color-aware mode
blind Color-blind mode
coupled Coupling mode
rate-type Setup rate type
data Data rate policing
line Line rate policing
type Setup policer type
mef MEF ingress bandwidth profile
single Single bucket policer
Default:
N/A
Usage Guide:
To update a profile for EVC Policer (Ingress Bandwidth Profile).
Example:
To update EVC Policer (Ingress Bandwidth Profile) with EIR 1000 for policer 1
Switch# configure terminal
Switch (config)# evc policer update 1 eir 1000
4.2.56 evc update
Command:
evc update <EvcId : 1-4096> vid <evc_vid> ivid <ivid> interface ( * |
10GigabitEthernet | GigabitEthernet [ <port_list> ] )
learning [ disable ] policer
{ <PolicerId : 1-2048> | none | discard }
<EvcId : 1-4096> EVC identifier
vid Setup EVC VLAN ID