Planet WGSW-24040HP4 - Factory Default; System Reboot

User’s Manual of WGSW-20160HP/WGSW-24040HP series
83
4.2.20 Factory Default
You can reset the configuration of the Managed Switch on this Page. Only the IP configuration is retained. The new
configuration is available immediately, which means that no restart is necessary. The Factory Default screen in Figure 4-2-27
appears.
Figure 4-2-27: Factory Default Page Screenshot
Buttons
: Click to reset the configuration to Factory Defaults.
: Click to return to the Port State Page without resetting the configuration.
To reset the Managed Switch to the Factory default setting, you can also press the hardware reset button
at the front panel about 10 sec
onds. After the device be rebooted. You can login the management WEB
interface within the same subnet of 192.168.0.xx.
4.2.21 System Reboot
The Reboot Page enables the device to be rebooted from a remote location. Once the Reboot button is pressed, user have to
re-login the WEB interface about 60 seconds later, the System Reboot screen in Figure 4-2-28 appears.
Figure 4-2-28: System Reboot Page Screenshot