Planet WRE-1200 - Page 50

User Manual of WRE-1200
42
A
uto channel selection will automatically set the wireless channel for the
access point’s 2.4GHz frequency based on availability and potential
interference.
When disabled, select a channel manually as shown in the next table.
Auto Channel
Range
Select a range from which the auto channel setting (above) will choose a
channel.
Auto Channel
Interval
Specify a frequency for how often the auto channel setting will
check/reassign the wireless channel.
Check/uncheck the “Change channel even if clients are connected” box
according to your preference.
Channel
Bandwidth
Set the channel bandwidth:
 20MHz (lower performance but less interference)
 40MHz (higher performance but potentially higher interference)
 Auto (automatically select based on interference level).
BSS Rate Set
Set a Basic Service Set (BSS) rate: This is the transmission rate for
controlling communication frames for wireless clients.
When auto channel is disabled, select a wireless channel manually:
Object Description
Channel Interval
Select a wireless channel from 1 – 11.
Channel
Bandwidth
Set the channel bandwidth:
 20MHz (lower performance but less interference),
 40MHz (higher performance but potentially higher interference)
 Auto (automatically select based on interference level).
BSS Rate Set
Set a Basic Service Set (BSS) rate: This is the transmission rate for
controlling communication frames for wireless clients.
The Wireless Settings can only be configured in the AP mode, not in the Repeater mode or
the Client mode.