To Next PageTo Next Page
Need help?Do you have a question about the Planmeca INTRA X-RAY UNIT and is the answer not in the manual?
General| Type | Intraoral X-ray Unit |
|---|---|
| X-ray Tube Current | 7 mA |
| Focal Spot Size | 0.4 mm |
| X-ray Tube Voltage | 60-70 kV |
| Exposure Time | 0.010 – 3.2 s |
| X-ray Field | Rectangular or round |
| Power Supply | 50/60 Hz |
| Dimensions | Varies depending on configuration (wall-mounted, mobile) |
Attach generator back plate to column with M6x16 screws and handle to back plate with M10x40 screws.
Attach wheel assemblies and base plate to column, ensuring a 3mm gap for firm attachment.
Position pins, route Intra cables through arm and column, attach horizontal arm with screws and washers.
Attach bracket arm shaft into bearing housing and secure with the locking plate.
Pull Intra cables, connect to generator PCB, and attach generator assembly to the back plate.
Connect the Intra cables to the Generator PCB as illustrated in the diagram.
Secure the generator housing to the generator assembly using three M4x6 ULS screws.
Place cover plugs, insert plugs into column openings, and secure bracket arm for transport.
