PH/PHX-2 Manual
45
MAINTENANCE
To achieve maximum output from the PH Series Proportioner, a daily or regular maintenance
schedule is required.
To prevent possible bodily harm caused by incorrect handling
of the raw materials and solvents used in the process, carefully
read the safety information provided by your supplier.
Deal with the waste created according to current regulations.
Disconnect the unit from the power supply before carrying out
any operation inside the electrical console.
The electrical maintenance of the machine must only be
performed by a qualified electrician.
To avoid damage caused by the impact of pressurized fluids,
do not open any connection or perform maintenance work on
components subject to pressure until the pressures have been
completely eliminated.
Use suitable protection when operating, maintaining or
remaining in the operating area of the unit. This includes, but
is not limited to, the use of masks, protective goggles, gloves,
shoes and safety clothing.
The unit includes components that reach temperature that are
liable to cause burns. The hot parts of the unit must not be
handled until they have cooled.
To prevent serious harm by crushing or loss of limbs, do not
work with the unit without the safety duly installed on all
moving parts. Make sure that all of the safety protections are
correctly fitted after all repair or maintenance work.
CAUTION!
All repairs performed by unqualified personnel or the use of parts
other than supplied by PMC may cause damage to the unit and put the operator
at risk.
To Next Page
Loading...
