PH/PHX-2 Manual
7
The PH Series Proportioner has been designed and built for the application of polyurea
chemical systems, polyurethane foam chemical systems, and some two-component epoxy
systems.
WARNING! The design and configuration of the PH Series Proportioner
does not allow its use in potentially explosive atmospheres or the pressure
and temperature limits described in the technical specifications of this
manual to be exceeded.
Always use liquids and solvents that are compatible with the unit. If in doubt, consult your
authorized PMC distributor.
When working with the PH Series Proportioner, it is recommended that the operator wear
suitable clothing and elements of personal protection, including, without limitation, gloves,
protective goggles, safety footwear and face masks. Use breathing equipment when working
with the PH Series Proportioner in enclosed spaces or in areas with insufficient ventilation. The
introduction and follow-up of safety measures must not be limited to those described in this
manual. Before starting up the PH Series Proportioner, a comprehensive analysis must be
made of the risks derived from the products to be dispensed, the type of application, and the
working environment.
To prevent possible injury caused by incorrect handling of the raw
materials and solvents used in the process, carefully read the
Material Safety Data Sheet (MSDS)provided by your supplier.
Deal with the waste caused according to current regulations.
To avoid damage caused by the impact of pressurized fluids, do not
open any connection or perform maintenance work on components
subject to pressure until the pressure has been completely
eliminated.
Use suitable protection when operating, maintaining or being present
in the area where the equipment is functioning. This includes, but is
not limited to, the use of protective goggles, gloves, shoes and safety
clothing and breathing equipment.
The equipment includes components that reach high temperatures
and can cause burns. Hot parts of the equipment must not be
handled or touched until they have cooled completely.
To prevent serious injury through crushing or amputation, do not
work with the equipment without the safety guards installed on the
moving parts. Make sure that all the safety guards are correctly
reinstalled at the end of the repair or maintenance work of the
equipment.
To Next Page
Loading...
