47
PRE-RIDE INSPECTIONS
Start the Engine and Check
n Engine Stop Switch: Check the auxiliary shut-off switch for
proper operation. Push down to stop the engine. Pull up to release
and allow starting of the engine.
n Tether Switch: Make sure the engine shuts off when the tether is
removed from the switch.
n Lighting: Check the headlight (high and low beam), taillight, and
brake light for normal operation.
n Check Surroundings to Verify Clear Operating Area: Make
sure you have a clear area all around your snowmobile, including
an area clear of bystanders. There’s always the possibility of some
sideways vehicle movement, of applying a little more throttle than
intended, or of debris being thrown by the track. If the
surrounding area is clear you before you start, you can devote your
full attention to operating the snowmobile.
To Next Page
Loading...
