81
MAINTENANCE
Headlights
Headlight Adjustment
The headlight may be adjusted for vertical aim using the following
procedure:
1. Place the snowmobile on a level surface with the headlight
approximately 25 feet (7.6m) from a wall.
2. Measure the distance from t he floor to the center of the headlight
and make a mark on the wall.
3. St art the engine and turn the headlight switch to high beam.
4. Observe the headlight aim. The most intense part of the headlight
beam should be aimed 2″ (5.1 cm) below the mark placed on the
wall in step 2.
NOTE: Rider weight must be included on the seat.
5. Turn the adjustment nut (1),
located inside the hood,
just below the headlamp
opening. Turn the knob in or
out as needed for proper aim.
x x
25’ (7.6 m)
2″ (5.1 cm)
1
To Next Page
Loading...
