3
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.
3.47
43.Secure the oil line with the springband clamp
r
.
44.Slide the oil tank into position and align mounting
holes with the mounting brackets on the clutch guard.
45.Install washers
e
and oil tank mounting fasteners
w
.
Torque fasteners to specification.
TORQUE
Oil Tank Mounting Fasteners:
7 ft-lbs (9 N·m)
46.Connect the oil level sender
q
.
47.Verify the oil tank has the specified amount of fluid.
48.Draw the recoil slowly then untie the knot in the rope
near the recoil housing. Pull rope through the
console.
49.Install the recoil handle.
50.Install the console. See Console Installation page
9.25.
51.If the vehicle is equipped with a battery, connect the
battery negative terminal at this time.
52.Install the resonator and tuned pipe. See Exhaust
Installation page 3.155.
53.Fill and bleed the cooling system at this time.
IMPORTANT
Review the important engine service notes prior to
starting engine. See Important Engine Service Notes
page .
54.Install the hood and side panels.
ENGINE / COOLING / EXHAUST
To Next Page
Loading...
Need help?
General
