3
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.
3.153
9. From the front of the snowmobile, remove the
exhaust springs
u
connecting the tuned pipe to the
exhaust manifold.
10.From the right side of the snowmobile remove the
bottom exhaust spring
i
connecting the tuned pipe
to the exhaust manifold.
NOTICE
An extended length exhaust spring tool aids in lower
exhaust spring removal.
11. Cut the routing clip
o
that secures the EGT sensor to
the load center.
12.Disconnect EGT sensor
a
.
13.Remove the tuned pipe.
ENGINE / COOLING / EXHAUST
To Next Page
Loading...
