6.22
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.
2. If removed, install snap rings
w
into housing with
sharp edge outward.
3. If removed, install new oil seals
e
into the backside
of the housing. The seal lips must face the bearing.
Drive on outer circumference of seals until seal
bottoms out in bore.
4. Obtain all nuts and fasteners required to mount the
chaincase housing to the vehicle.
5. Reference Adhesive Applicator Kit and Adhesive
Application sections in Chassis chapter.
NOTICE
The Bonded Component Service section in Chapter 9
outlines the adhesive, applicator tools, and the
adhesive application procedure required to properly
install bonded components.
6. Apply adhesive to the housing’s rear mounting
flanges and front spar as shown in the illustration
r
.
7. Apply adhesive to the right clip as shown in the
illustration
t
.
8. Install the chaincase housing. Loosely install
fasteners
y
that secure the chaincase housing to the
front clip and bulkhead cooler.
FINAL DRIVE / BRAKE SYSTEMS
To Next Page
Loading...
Need help?
General
