10.22
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.
5. Connect the handlebar connections connector
r
and
left hand controls connector
t
from the main
harness. Make sure the connectors get secured to
the air box with the Christmas tree clips on the
connectors.
6. Place console switch panel
w
near its installed
position and connect the main harness key switch
connector to the key switch
e
.
7. Install the two push rivets securing the console switch
panel.
IMPORTANT
If a heater is replaced, it must be calibrated with Digital
Wrench, otherwise the control will not be accurate.
If more than one heater is replaced, the CALIBRATE
ALL option in Digital Wrench will be necessary.
BATTERY / ELECTRICAL
To Next Page
Loading...
Need help?
General
