10
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.
10.57
4. Install the display wire cover
i
onto the display door
using the bottom two display fasteners
o
. Torque
fasteners to specification.
NOTICE
Make sure the tab of the display wire cover is installed
into the holder on the back of the display door.
TORQUE
Display Fasteners:
53 in-lbs (6 N·m)
5. Close the display door
a
and flip the hood over.
6. Install edge clip or new cable tie
s
to secure the
hood harness to the tab on the display wire cover.
7. Reinstall the hood and side panels.
BATTERY / ELECTRICAL
To Next Page
Loading...
Need help?
General
