To Next Page

To Previous Page

9929422 R02 - 2017-2019 ACE 900 Service Manual

2.39

DRIVE SHAFT BOOT INSPECTION

Inspect the front and rear drive shaft boots

for

damage, tears, wear or leaking grease. If the boots

exhibit any of these symptoms, they should be replaced.

Check to see the boot clamps

are properly positioned.

See “Drive Shaft CV Joint / Boot Replacement” page

7.20 for drive shaft boot replacement.

WHEEL AND HUB TORQUE TABLE

ITEM SPECIFICATION

Wheel Nuts

(Aluminum Wheels)

30 ft-lbs + 90° (41 Nm)

Hub Retaining

Nuts

Front

110 ft-lbs (149Nm)

Rear

110 ft-lbs (149Nm)

NOTE

Do not lubricate the stud or the lug nut.

WHEEL REMOVAL

1. Position the vehicle on a level surface.

2. Place the transmission in PARK and stop the engine.

3. Loosen the wheel nuts slightly. If wheel hub removal

is required, remove the wheel cap, cotter pin and

loosen the hub nut slightly.

4. Elevate the appropriate side of the vehicle by placing

a suitable stand under the frame.

5. Remove the wheel nuts and remove the wheel.

MAINTENANCE

Polaris ACE 900 2017 User Manual

Questions and Answers: