Polaris BRUTUS Owner's Manual

107
MAINTENANCE
PTO Clutch (If Applicable)
Description
The PTO system is activated by engaging an electric clutch.
When the clutch is engaged, the PTO driveline will rotate.
When disengaged, a PTO brake is applied.
The PTO clutch brake must be checked and adjusted periodi-
cally as outlined in the Periodic Maintenance Chart beginning
on page 78.
Adjusting The PTO Clutch Brake
Put the gear selector in Park,
stop the engine and exit the
vehicle. See page 41.
Remove the passenger seat
and the storage container to
access the PTO clutch. See
page 25.
Use a feeler gauge (Item 1),
and insert the end of the
feeler gauge into the edge of
the clutch pack to a depth of
0.31 in (8 mm) and measure
the clearance. Measure in
three places (in the three
openings in between the
three adjusting nuts) to
determine that the clearance
is the same for all three areas
on the clutch pack.
The correct clearance is
0.014 in (0.35 mm).
Tip: Do not insert the end of the
feeler gauge more than
0.31 in (8 mm) into the side
of the clutch to get an accu-
rate measurement.
Tighten or loosen the three
adjusting nuts (Item 2) until
the correct clearance is
achieved evenly (at the three
areas checked) on the clutch.
The PTO clutch is removed.
2
1
2
2
1
2
4
0.31 in.
(8 mm)
1

Polaris BRUTUS Specifications

General

Brand	Polaris
Model	BRUTUS
Category	Utility Vehicle
Language	English