47
OPERATION
Attachments (Models HD and HDPTO)
Installing And Removing Attachments
The PRO-TACH attachment system is used for fast changing of buckets and other
attachments. See the appropriate Attachment Owner’s Manual to install other attachments.
Installing:
1. Remove the two retainers and pins from the
storage position.
2. Start the engine. See page 39. Move the gear
selector lever to LOW.
3. Lower the attachment arm and tilt the attachment
interface forward.
4. Slowly drive forward until the front edge of the
attachment interface is completely under the top lip
of the attachment.
5. Tilt the attachment interface backward until the
attachment is slightly off the ground.
6. Move the gear selector lever to PARK and stop the
engine. See page 40.
7. Install the two pins and retainers (both sides).
8. Connect the auxiliary hydraulic hoses (if
equipped). See page 44.
9. Connect the PTO driveline (if equipped). See page
49.
Pins
Retainers
Lip of the attachment
Pin
Retainer
To Next Page
Loading...
Need help?
General
