ENGINE
3.45
FLYWHEEL/STATOR REMOVAL/INSPECTION
1. Remove flywheel nut and washer.
2. Install flywheel puller (PN 2870159) and remove
flywheel. CAUTION: Donot threadthepullerbolts
into the flywheel more than 1/4″ or stator coils may
be damaged.
3. Mark or note position of stator plate on crankcase.
4. Remove bolts and carefully remove stator
assembly, being careful not to damage crankshaft
bushing on stator plate.
5. Replace crankshaft seal.
6. Remove oil passage O-Ring.
7. Remove large sealing O-Ring from outer edge of
stator plate.
NOTE:If bushing is to be replaced, oil hole in bushing
must align with hole in stator plate.
A
Oil hole in bushing
To Next Page
Loading...
