Ill. 3
Puller Legs
Ill. 4
Position the split
90° to opening
on main puller
body
Main puller
body
Hex Socket Screws
Ill. 5
Lip must grasp inside
of mechanical seal.
Puller Legs
Ill. 6
ENGINE
3.62
WATER PUMP MECHANICAL SEAL REMOVAL - ENGINE
INSTALLED
, CONT.
3. Insert the puller legs between the water pump drive
shaft andtheremainingportion of the mechanicalseal.
Attach the puller legs to the main puller body. Ill. 3
4. Ensurethatthesplitbetweenthepullerlegsis fullysup-
ported by the main body of the tool (Ill 4).
5. T ighten the hex socket screws on the puller legs suffi-
ciently so the lip of the puller legs will grasp the me-
chanical seal. Ill. 5
6. T urn the puller T-Handle clockwise until it contacts the
water pumpshaft. Continuerotatinguntiltheremaining
portion of mechanical seal has been removed from the
cases. Ill. 6 Pump shaft oil seal can also be replaced
at this time if necessary.
7. Special tool (PN 5131135) is required to install thenew
mechanical seal. This tool is available separately and
it is also included in the Crankshaft/Water Pump Seal
Installation Kit (PN 2871283).
To Next Page
Loading...
