CLUTCH
6.24
DRIVE CLUTCH COVER - BUSHING REMOVAL
1. Install main adapter (Item 8) on puller.
2. From outside of clutch cover, insert removal tool
(Item 3) into cover bushing.
3. With inside of cover toward vise, slide cover onto
puller.
4. Install nut onto puller rod and hand tighten. T urn
puller barrel to increase tension as needed.
5. T urn clutch cover counterclockwise on puller rod
until bushing is removed.
6. Remove nut from puller rod and set aside.
7. Remove bushing and bushing removal tool from
puller. Discard bushing.
Main Adaptor
Piston Pin Puller
PN 2870386
To Next Page
Loading...
