FINAL DRIVE
7.3
FRONTHUBREMOVAL(AWD)
If an A WD problem is encountered, thoroughly inspect
the electrical portion of t he system as well as the front
hub mechanism. Refer to the electrical chapter.
1. Carefully lift and support the front end of the
machine as shown with the jack stands under the
front end of the foot rests. CAUTION: Make sure
themachineis solidlysupportedbeforeproceeding.
Seriousinjurycouldoccurifthemachinetipsorfalls.
2. Remove the front wheels and thoroughly clean the
areaaroundthehub,strutcasting,brakecaliperand
brake disc.
3. Remove the two brake caliper attaching bolts.
CAUTION: Do not hang the caliper by the brake
hose. Use wire to hang the caliper to prevent
possible damage to the brake line or speed sensor.
4. Placeacatchpanbeneaththefronthubandremove
the hub cap.
5. Remove cotter pin and nut.
6. Remove front hub and bearings.
To Next Page
Loading...
