TRANSMISSION
8.23
FRONT OUTPUT HOUSING (SNORKEL) INSTALLATION
9. Install front output ring gear, washer , and retaining
bolt with a new lock plate. Hold shaft with strap
wrench and tighten retaining bolt. Clean threads of
boltandshaftwithLoctite™ PrimerN. ApplyLoctite™
242 or 243 (blue) to retaining bolt threads. Torque
bolt to specification and bend lock plate against
hexagonal portion of bolt.
10. Installpiniongearassemblyandretainingplate. Use
Loctite™ Primer N on threads and housing. Apply
Loctite™ 242 to bolts and torque to specification.
FRONT OUTPUT HOUSING (SNORKEL) BACKLASH ADJUSTMENT
11. Lubricate front housing O-ring thoroughly with
Polaris All Season grease. Continue to screw front
housing in, making sure O-ring enters housing
without damage. Be sure ring and pinion gear teeth
mesh properly.
12. Rotate front shaft while slowly turning housing
inward. As gear backlash is reduced to zero, the
shaft willbegintobind. Atthispoint backoff1/4turn.
Ring Gear Retaining Bolt
17 - 20 ft. lbs. (24-27 Nm)
Apply Loctite™ 242 or 243 (Blue)
Pinion Gear Retainer Screws:
17 - 20 ft. lbs. (24-27 Nm)
Apply Loctite™ 242 or 243 (Blue)
To Next Page
Loading...
