BRAKES
9.10
MASTER CYLINDER DISASSEMBLY
1. Remove cover and diaphragm from master cylinder
and dispose of the fluid properly.
2. Be sure vents in cover are clean and unobstructed.
3. Remove brake lever.
4. Clean surfaces of the reservoir and master cylinder
body. Besuresupplyport isclean beforereassembly.
5. Remove outer dust seal. Be ready to catch piston
assembly. NOTE: The return spring may force piston
out when dust seal has been removed.
6. Remove piston assembly and return spring from
mastercylinder. Replace pistonassemblyandspring.
Vent Slots
Cover
Supply Port
Outer Dust Seal
To Next Page
Loading...
